Design of Hardware in Loop Simulation Platform for Intelligent Control System of Corn Kernel Harvester

ZHU Xiaolong, CHI Ruijuan, DU Yuefeng, BAN Chao, MA Yueqi, HUANG Xiulian

Abstract

Aiming at the problem that the development of a low loss threshing intelligent control system for corn kernel harvester is greatly affected by the experiment site and season, a set of hardware in loop simulation platform for low loss threshing intelligent control system was designed and developed. The simulation platform was composed of a simulation platform controller, operation panel, demonstration panel, armrest box, display, and upper computer. The composition of the intelligent control system for low loss threshing of the corn kernel harvester and the test requirements of the harvest controller was analyzed. The mathematical model of the adjustment process of the key operating parameters of the corn kernel harvester was established. The hardware in the loop simulation test system was built based on an STM32F407 single-chip microcomputer, and the testbed design was completed. The open-loop contrast test of operation parameter adjustment of the simulation platform and the corn grain harvester under no-load conditions was carried out. The mathematical expectation of the simulation error of the cylinder speed was 0.126r/min, and the standard deviation was 0.776r/min. The mathematical expectation of operating speed simulation error was -0.022km/h, and the standard deviation was 0.094km/h. The mathematical expectation of the concave clearance simulation error was 0.041mm, and the standard deviation was 0.147mm, which verified the effectiveness of the simulation platform for the adjustment process of the actuator of the corn harvester was verified. The signal simulation test and the automatic control strategy simulation test of the harvest controller were carried out. The results showed that the simulation platform can be used for the development of an intelligent control system for corn kernel harvester and the test of control strategy, which improved the system development efficiency and shortened the development cycle.

 

Keywords: corn kernel harvester, low loss threshing, hardware in loop simulation, intelligent control system

 


Download Full Text:

PDF


References


WANG K R, XIE R Z, MING B, et al. Review of combine harvester losses for maize and influencing factors [J]. International Journal of Agricultural and Biological Engineering, 2021, 14(1): 1 -10.

WANG Keru, LI Lulu, LU Zhensheng, et al. Mechanized grain harvesting quality of summer maize and its major influencing factors in Huanghuaihai region of China [J]. Transactions of the CSAE, 2021, 37(7) : 1 -7. (in Chinese)

WANG Zhendong, CUI Tao, ZHANG Dongxing, et al. Design and experiment of rasp bar threshing element of corn combine harvester [J]. Transactions of the Chinese Society for Agricultural Machinery, 2021, 52(9) : 115 -123. (in Chinese)

WANG Zhendong, CUI Tao, ZHANG Dongxing, et al. Design and experiment of low damage corn threshing drum with gradually changing diameter[ J ]. Transactions of the Chinese Society for Agricultural Machinery, 2021, 52(8): 98 - 105.

WAELTI H, BUCHELE W. Factors affecting corn kernel damage in combine cylinders[J]. Transactions of the ASAE, 1969, 12(1): 55 -59.

CHOWDHURY M, BUCHELE W. The nature of corn kernel damage inflicted in the shelling crescent of grain combines [J]. Transactions of the ASAE, 1978, 21(4): 610 -614.

LI Shaokun. Factors affecting the quality of maize grain mechanical harvest and the development trend of grain harvest technology [J]. Journal of Shihezi University( Natural Science) , 2017 , 35 ( 3 ) : 265 - 272. ( in Chinese)

SPECKMANN H, JAHNS G. Development and application of an agricultural BUS for data transfer[J]. Computers and Electronics in Agriculture, 1999, 23(3) : 219 - 237.

CRAESSAERTS G, DE BAERDEMAEKER J, SAEYS W. Fault diagnostic systems for agricultural machinery [J]. Biosystems Engineering, 2010, 106(1) : 26 - 36.

REID J, ZHANG Q, NOGUCHI N, et al. Agricultural automatic guidance research in North America[J]. Computers and Electronics in Agriculture, 2000, 25(1) : 155 - 167.

JIN Chengqian, CAI Zeyu, YANG Tengxiang, et al. Design and experiment of yield monitoring system of grain combine

harvester [J]. Transactions of the Chinese Society for Agricultural Machinery, 2022 , 53 ( 5 ) : 125 - 135. ( in Chinese)

LI Qinglin, SONG Yuying, YAO Chengjian, et al. Intelligent design and optimization system for cleaning device of rice and wheat combine harvester[ J] . Transactions of the Chinese Society for Agricultural Machinery, 2021, 52 ( 5 ) : 92 - 101 .

WANG Jinwu, TANG Tianyong, TANG Han, et al. Design and experiment of on-line detection device for capacitive paddy rice

moisture content of combine harvester [ J ] . Transactions of the Chinese Society for Agricultural Machinery, 2021 , 52 ( 3 ) : 143 - 152.

TAO Fei, LIU Weiran, LIU Jianhua, et al. Digital twin and its potential application exploration [ J ] . Computer Integrated Manufacturing Systems, 2018, 24(1) : 1 -18. (in Chinese)

XING Jie, HE Hongwen, SUN Fengchun. Platform of hardware in the loop for hybrid control strategy test[J]. Transactions of Beijing Institute of Technology, 2010, 30(8) : 887 -890. (in Chinese)

ZHU Qinglin, WANG Qingnian, CENG Xiaohua, et al. Development platform for HEV energy management system based on V-mode and its application[J]. Journal of Jilin University(Engineering and Technology Edition) , 2007,37(6) : 1242 - 1246.

SHI Qiwen, SUN Xiaomin. Research and implementation on MATLAB based rapid control prototype software platform for vehicle control[J]. Computer Engineering and Applictions, 2005(13) : 108 -110. (in Chinese)

LI Jing, LI Youde, ZHAO Jian, et al. A hardware-in-the-loop test bench for traction control system [J]. Automotive Engineering, 2005, 27(1) : 64 -67.

XU Guangfei, PANG Huanxiao, CHEN Meizhou, et al. Design of hardware in loop tractor electro-hydraulic coupling steering test platform[ J]. Transactions of the Chinese Society for Agricultural Machinery, 2020, 51 (Supp. 1 ) : 525 - 534. (in Chinese)

XU Hailong, XU Liyou, LIU Xiaohui, et al. Design of CAN communication network and HIL test for electric tractor [J]. Agricultural Equipment & Vehicle Engineering, 2020, 58(4): 1 -5. (in Chinese)

WU Zhongbin, XIE Bin, CHI Ruijuan, et al. Driving torque management model for electric tractor in field cruise condition [J]. Transactions of the CSAE, 2019, 35(4) : 88 -98. (in Chinese)

QIN Yun, ZHAO Dean, ZHANG Chao, et al. Design of a hardware-in-loop simulation platform for combines load control [J] . Transactions of the CSAE, 2011, 27(1) : 142 -147. (in Chinese)

ZHU Xiaolong, CHI Ruijuan, DU Yuefeng, et al. Design and experiment of intelligent control system for low loss threshing of high moisture content corn [J]. Transactions of the Chinese Society for Agricultural Machinery, 2021,52(Supp. ): 9 -18.

ZHANG Zhen, CHI Ruijuan, DU Yuefeng, et al. Investigation on CAN-bus-based corn harvester intelligent control system [J].

Transactions of the Chinese Society for Agricultural Machinery, 2018, 49(Supp. ) : 275 -281. (in Chinese)

QIN Yun, ZHAO Dean, LI Fazhong, et al. Constant palstance control of combine cylinder based on RBF[J] . Transactions of the Chinese Society for Agricultural Machinery, 2009, 40(11) : 59 -63. (in Chinese)

SUN Baofu, MAO Kaiping. Dynamic characteristics of variable displacement pump and fixed displacement motor volume

speedmodulating system[J]. Mechanical Engineering & Automation, 2013(5) : 53 -55. (in Chinese)

ZHU X, CHI R, DU Y, et al. Experimental study on the key factors of low-loss threshing of high-moisture maize [J]. International Journal of Agricultural and Biological Engineering, 2020, 13(5) : 23 - 31.


Refbacks

  • There are currently no refbacks.